Laser cutting machine operating regulations

Laser cutting machine in the operation process there is a danger, so the novice must accept the training of professionals to operate independently, so the author summarized the laser cutting machine safety work of 10 details according to the experience, of course, the following instructions for the basic principles, need to develop this line according to their own situation.

① Comply with the general cutting machine safety operating procedures. And start the laser in strict accordance with the laser start-up procedure. After starting the laser cutting machine, manually move the X and Y axes at low speed to check whether there is any abnormal situation. ② The operator should be trained, familiar with the structure and performance of the laser cutting machine, and master the relevant knowledge of the operating system. ③ Wear labor protection products according to the regulations, and wear protective glasses that meet the regulations near the laser beam. ④Before processing, it is necessary to confirm whether the material is suitable for laser irradiation or heating to avoid dangerous substances such as smoke and steam. ⑤ When the laser cutting machine is working, it is necessary to observe the operating status of the equipment. After the equipment is started, the operator shall not leave the post or entrust others to manage it. When leaving, the operator shall stop the equipment and turn off the power switch. ⑥ Fire extinguishers should be placed in a place within easy reach; Close the laser or gate when not processed; Do not place flammable materials in the area around the unshielded laser beam. Keep laser cutting machine laser, bed and the surrounding site clean and orderly without oil, according to the provisions of the stacking of workpieces, plates and waste materials. ⑦ In the process of finding abnormal conditions should immediately stop the equipment and timely troubleshooting or report to the supervisor. ⑧ The use of gas cylinders must comply with the monitoring procedures to avoid leakage accidents, and pay attention to safety issues during transportation and use of gas cylinders; Do not expose gas cylinders to sunlight or near high temperature sources; Open the cylinder valve door must stand above its side position to operate. ⑨ The maintenance process needs to follow high pressure safety specifications, and the corresponding inspection and maintenance tasks need to be carried out according to procedures before the arrival of every 40 hours of operation, weekly maintenance, every 1000 hours of operation or every 6 months of maintenance cycle. ⑩ Test run new programs and check their validity before entering them.

As a professional laser equipment manufacturer, men-luck provides all kinds of laser cutting machines, laser welding machines, laser marking machines, support sending samples and proofing, and develop high-quality system solutions for customers. Welcome enterprises to consult and understand.